Does the star TSP100 use ink?

ByEditor

Does the star TSP100 use ink?

The thermal print head heats up and reacts with chemicals on the paper to produce the printout – No ink or ribbons required! Since no ink or ribbon is required, printouts are clean, crisp, and never run or smear.

Why is my star TSP100 won’t print?

To troubleshoot the Star TSP 100 LAN printer: Plug the ethernet cable into the back of the printer. Ensure the other end of the Ethernet cable is connected to the router or a switch leading to the router. Press and hold the paper feed button while turning the printer back on.

How do I connect my TSP100 to my iPad?

iOS

  1. Open the setting screen of the tablet and select Bluetooth.
  2. Turn Bluetooth from Off to On.
  3. Select the device name (TSP100-XXXXX) to connect. If the device name was changed, then select the device name that it was changed to.
  4. If you are unable to connect, please refer to FAQ – Cannot connect the tablet.

How do I connect my star TSP100 printer to Internet?

Connect by WPS

  1. Check the printer’s power is on, and open TSP100III Utility.
  2. Tap [Unselected State] from “Selected Device”.
  3. From the Select Device list , select the device you want to connect and then tap [Apply].
  4. Tap [Change Network Settings]. This connects to the selected printer and opens the Web Configuration.

What kind of paper does the star TSP100 use?

Thermal Receipt Paper
A. The standard Star TSP100 paper size is 3 1/8″ x 230′. Buy 3 1/8″ x 230′ Thermal Receipt Paper (50 Rolls) here. Our 3 ⅛” x 230′ thermal paper rolls are high-quality, BPA-free, and available for Free, Same-Day Shipping!

What size paper does a star SP700 printer use?

STAR MICRONICS SP700 (All) 1-Ply 3 inch x 165′ Paper 50 Rolls.

Why is my thermal printer printing blank?

Depending on the application, it is possible that the roll of paper has the thermal coating on the wrong side, or the paper has been installed wrong. Remove the thermal paper roll. Rotate the roll 180° and reinstall so that the opposite side of the paper is being printed on. Run a test print.

How do you test a star TSP100?

With the printer powered OFF, please press and hold down the “FEED” button. Power the printer ON, only releasing the FEED button when the self-test starts to print. For most Star printers, the hardware self-test will begin right away, if it does not, hold the FEED button until the printer starts to print.

How do I connect my iPad to a LAN printer?

Create a Printer Station and Connect a Printer to Your iPad

  1. Locate your wireless router with Ethernet port and make sure you have a strong Wi-Fi signal.
  2. Connect one end of the Ethernet cable into the rear panel of the printer, and plug the other end of the cable into the wireless router’s Ethernet port.